Likely a dumb question, but is there any way to configure the opto inputs of a SnapAmp to work as outputs? I was hoping to use them for signals to a 12V PLC.
Thanks in advance, David.
Group: DynoMotion
Message: 11465
From: Tom Kerekes
Date: 5/4/2015
Subject: Re: SnapAmp Opto Inputs as Outputs?
Hi David,
No sorry that is not possible. Consider adding a Konnect.
Regards
TK
Group: DynoMotion
Message: 11466
From: David Stevenson
Date: 5/4/2015
Subject: Re: SnapAmp Opto Inputs as Outputs?
Thanks Tom.
Unfortunately I don't have the real estate to put one in the
electrical cabinet.
Best regards,
David.
On 5/4/2015 1:51 PM, Tom Kerekes
tk@... [DynoMotion] wrote:
Hi David,
No sorry that is
not possible. Consider adding a Konnect.
